这是我第二个作品，大家有什么意见可以告诉我，我会采纳。

首先，这个模型适用于500g的焊锡丝，宽度为6cm

其次，底部采用了镂空设计，可以嵌入4颗直径为5mm的磁铁（以防止焊锡丝使用后重量变轻，拖拽位移）

设计了三个孔洞，以方便从不同角度拉取焊锡丝

安装好磁铁后，可以将其吸附在热风枪盒子上或其他铁制部件上

打印时无需使用支撑结构，可一次成型。方便快捷

This is my second work. If you have any comments, please let me know and I will take them.

Firstly, this model is adapted to 500g solder wire with a width of 6cm

Secondly, the bottom has been designed with a hollow out, which can be embedded with 4 magnets with a diameter of 5mm (to avoid the weight reduction and dragging displacement of the solder wire after use)

Design with three holes for pulling solder wire at different angles

After installing the magnet, it can be adsorbed on the hot air gun box or other iron parts

Printing does not require support and can be formed as a whole. Convenient and fast.